About this item
●Saving place -
The combination of amplifier and subwoofer all into one, makes this ideal for spatially challenged vehicles. With a slim design, there are a few installation options.●Built-in Amplifier -
A built-in 150 watt class D amplifier powers the subwoofer
●Pulse Width Modulated -
This design controls the output voltage and current precisely by not only removing the output current sensing loss, but also eliminating all secondary feedback circuitry. It increases efficiency, is lighter, smaller reliable
●Variable Low-Pass Filter -
A low-pass filter is an electronic circuit that removes all the notes below the filter's frequency setting. You will use the Low-pass filter to primarily keep high notes out of your subwoofer(s)
●High Level Input -
Speaker level inputs are commonly referred to as high-level inputs. It will be used to connect the T6 to your factory radio or an aftermarket radio that does not have low-level (RCA) inputs
●Low Level Input -
Line level inputs, also known as RCA inputs or low-level inputs, use RCA interconnect cables to link the T6 with the source unit. Most aftermarket radios have multiple pairs of RCA outputs that can connect to multiple amplifiers
●Variable Bass Boost -
Variable Bass Boost allows you to adjust the low bass within the boost range to just the way you like it
| SPC | Model | T6 Bass |
| Type | Active Subwoofer | |
| Power Supply | DC14.4V(9V-16V) | |
| Rated Power | 150W | |
| Peak Power | 300W | |
| Speaker Size | 6 Inch*8 Inch | |
| Frequency Response Range | 30Hz ~ 160Hz | |
| Low Frequency (LP) | 30Hz ~ 100Hz | |
| Impedance | 3.6 Ω | |
| SNR | ≥92db | |
| Distortion | ≤ 0.2% | |
| RCA Input Sensitivity | 100mv | |
| Speaker Input Sensitivity | 1.8V | |
| Short-circuit Protection | Support | |
| Overheat Protection | Support | |
| Size (length /width /height) | 285mm /205mm /76mm | |
| Weight | 4.5Kg | |
| Material | Aluminum |
●T6 Host
●Wire Control
●Wire Control Cable High Level Cable
●Screws * 8 sets
●Screws *4 sets
●Fixing Piece * 4 sets